Thank you! That would make sense as I forgot to mentioned that it all happened after I pressed the dimmer switch. I will start there.

Thank's again!

Hello, I am trying to diagnose an issue I had a couple of days ago with my M37 lights. While driving the vehicle, all lights went off. I turned the switch to off and tried turning them back on many times but they did not turned on. I played around with the three lever switch and a couple of times, t...

Hello, I recently purchased a new canvas cab top and I am having issues installing it and making it fit. It seems like I can not strecht it enough to make it correctly over the top bow. OR the canvas top was not made corrctly. On the back side where it ties to the cab, it barely passes the edge of t...

Hello,

Looking for wisdom. Does anyone know what was the auxiliary power port next to the glove compartment used for? Where can I find the plugn-in cable?

Rafael

Thank you Gary!

Thank you!

Is the winch on an M715 the same as the one for the M37? I have one and I am trying to find out if I can use it on my M37.

Thank you!

Thank you!

Anyone knows if the SKF UJ304 u joints will fit on the intermediate shaft? I read on a different thread that Napa #304 will fit so I just want to make sure the SKF UJ304 is a replacement number and fits.

Thank you in advance!

Thank You m-11!

Thank you both! anyone knows the timken numbers for the bearings and cups? Maybe I can find them locally.

Hello, Looking for wisdom/guidence. Looking for opinions in preference between using the roller bearings on the upper side of the steering knuckle as opposed to the bronze cone. And also, Are they the same size? top and bottom I have movement, in/out, on the steering knuckles. I tried adjusting it w...

Thank you!

Thank you, Andy. Everything I read says it is adjusted at 3200 RPM's. Is it that it needs to be acelarated at that rate while adjusting? or that it should not be adjusted to acelerated more than that? I am not understanding the procedure on the TM well.

Have you done it?

Rafael

Hello,
Is it possible to eliminate the governor on a ETW1 carburetor? My M37 runs very slow and it does not accelerate smoothly. It is hard to rev up and dies down when going up-hill.

Rafael