oil press. sender

hairpin151 · Post by **hairpin151** » Tue May 27, 2008 6:33 am

Anyone got an extra 0-60lbs sender with the metal (Douglas) connector? I'm thinking thats the culprit as my gauge pegs to 60lbs and stays there and I've tried a different gauge,same thing. Any help is appreciated.Thanks.

hairpin151 · Post by **hairpin151** » Tue May 27, 2008 9:38 am

Got one from Jay at FLMV,installed and all is well.Thanks

monkeymissile · Post by **monkeymissile** » Tue May 27, 2008 3:46 pm

could you post their contact info when you get a chance? I may need one too. Thanks.

hairpin151 · Post by **hairpin151** » Tue May 27, 2008 3:50 pm

717-252-4489, dont have their web address in front of me.

N1VSM · Post by **N1VSM** » Wed May 28, 2008 4:04 pm

hairpin151 wrote:Got one from Jay at FLMV,installed and all is well.Thanks

I've been trying to track down a problem in my temp gauge. I checked the wire (it is fine - new), swapped out both the gauge and the sensor with ones that tested good.

Could you (or anyone?) tell me what voltages or resistances I should measure when testing cold and hot?

hairpin151 · Post by **hairpin151** » Sun Jun 01, 2008 1:41 pm

I wish I could help but fraid not.I would defer to the 8030 manual possibly.

m-11 · Post by **m-11** » Mon Jun 02, 2008 5:46 am

Are you looking for this website? www.flmv.net

oil press. sender

oil press. sender

If you have the chance ...