The only thing you need in Maryland is an open title one you can transfer over to you. New repo Vin plates are helpful in these situations as well. No need to volunteer more information than is needed to MVA.

Maybe consider one that's done or closer to being done. I hope they didn't take advantage of you on what little damage or progress they've already done.

Nice build glad you stayed with it. Enjoyed the photos.

Thanks

Master Yota wrote:That thread was in the builders blog section...

To bad I'd like to have seen that completed. Because I have 2 of those motors in the garage.

There's a very good possibility I will be doing a repower on my running 1952 M37 and would like to see if there is an interest to someone here for my 230 and trans. I'm figuring its gotta be worth $600.00 I'm located in Baltimore Maryland.

Did I see a post sometime ago of someone installing a Ford 351 W motor in to their M37 or is my memory playing tricks on me. Just wonder if the Front Sump oil pan on the ford small blocks create issues.

Is anybody running non military plugs and wires on the M37 24 volt system with any success??

Beachwood canvas has a top made of some type of vinyl that's really reasonable they say its for the person who works their truck. Is like 195.00 and is olive drab.

I'd love to get mine to the point where it becomes my daily driver like his.

Thanks. I think I'll go with Beachwood they done a good
Job with my MB.

My Cab has 9 Hooks that holds the top down around the bottom and I want to order a new top. When ordering do I need to specify the number of hooks or do they all have the same number ? Also who has the best fitting top out there? I would like to hear the pros and cons, they all look to be in the sam...

List it over on the Steel soldiers site, hope someone saves it.

That is truly amazing. I would have gone crazy doing that even if i could have done that. I want one.

https://scontent-b-sjc.xx.fbcdn.net/hphotos-prn2/t1/1625744_10203031420215912_2038309048_n.jpg This is the dualmatic hub, very close... https://scontent-b-sjc.xx.fbcdn.net/hphotos-ash3/t1/1604704_10203031418775876_767187702_n.jpg This is what I started with, rust... https://scontent-b-sjc.xx.fbcdn....

I would love to have the upper cowl sheetmetal, mine has been patched before and I'm not sure I can salvage the cowl vent because it was poorly done last time.