Ok I have misplaced where the large ball barring goes in the

bubba_got_you · Post by **bubba_got_you** » Wed Oct 22, 2008 7:22 pm

Ok I have misplaced where the large ball barring goes in the carburetor. Any one know where it goes or have an exploded view?

MSeriesRebuild · Post by **MSeriesRebuild** » Sat Oct 25, 2008 7:55 am

bubba_got_you wrote:Ok I have misplaced where the large ball barring goes in the carburetor. Any one know where it goes or have an exploded view?

The only ball bearing in the carb is on the throttle shaft.

bubba_got_you · Post by **bubba_got_you** » Sat Oct 25, 2008 3:08 pm

MSeriesRebuild wrote:
bubba_got_you wrote:Ok I have misplaced where the large ball barring goes in the carburetor. Any one know where it goes or have an exploded view?
The only ball bearing in the carb is on the throttle shaft.

I have 3 one small one medium and one large

MSeriesRebuild · Post by **MSeriesRebuild** » Sat Oct 25, 2008 5:14 pm

I realized you are talking about something else after reading a post you had on the PWA forum. You are speaking of a ball, not a ball bearing. The large ball goes under the snap ring in the bottom of the pump plunger bore.

Ok I have misplaced where the large ball barring goes in the

Ok I have misplaced where the large ball barring goes in the

Re: Ok I have misplaced where the large ball barring goes in

Re: Ok I have misplaced where the large ball barring goes in