Generator probs?
Moderators: Cal_Gary, T. Highway, Monkey Man, robi
- hairpin151
- PFC
- Posts: 74
- Joined: Thu Mar 06, 2008 4:05 am
- Location: Sunny Southwest-AZ
Generator probs?
I think I might need a new generator as my gauge shows the low side of the yellow and its cranking slower and slower.Any ideas or where can I get a new generator without breaking the bank?Thanks.
- uglyranger
- PFC
- Posts: 86
- Joined: Mon Jul 21, 2008 6:02 am
- Location: Georgia
- hairpin151
- PFC
- Posts: 74
- Joined: Thu Mar 06, 2008 4:05 am
- Location: Sunny Southwest-AZ
It could be that your generator output isn't up to snuff, or your voltage regulator could be limiting the output. Any decent automotive electrical shop can test, clean, and/or rebuild your generator for way less than a replacement would cost you. I'd get that checked out first. If it solves the problem, the regulator is probably okay.
"PER ARDUA AD ITER"
Re: Generator probs?
Before you run out to buy a new generator....hairpin151 wrote:I think I might need a new generator as my gauge shows the low side of the yellow and its cranking slower and slower.Any ideas or where can I get a new generator without breaking the bank?Thanks.
Is it in the yellow while it is running? Is it in a different location when the engine is not running and switch is on? How much does the needle drop while it is cranking....
Don't use the approach of some old Army Mechanics "Repair by Replacement"
When i first took over as CO I think my motor pool followed the following diagnostic...Truck won't start?? ...replace batteries, still won't start replace starter motor, then plugs, then wires etc....turn in to support....
Paul f
- hairpin151
- PFC
- Posts: 74
- Joined: Thu Mar 06, 2008 4:05 am
- Location: Sunny Southwest-AZ
I recently went through the same thing. It was my generator. I got a used one that is the same for the M35 that is an alternator verses a generator with an external regulator. There is a thread on this forum concerning it. I got a used generator from a place in florida for about 130 shipped. That one part has 60 amp capacity verses the original 25 amp capacity, if you do determine that you have to replace it you may want to go this way as an alternative that is still mil issue parts and waterproof like the original.
Mark
Mark
Mark Ellis
1953 M37 WOW
1967 M101A1
NRA Life Member
USMC Retired
1953 M37 WOW
1967 M101A1
NRA Life Member
USMC Retired
If the volt meter isn't moving running vs. off then you are probably not charging your batteries (and they are running down ...sl;ow cranking). You could also verify this by using your multimeter and reading voltage running and off.
Para 92 TM 9-8030 has detailed diagnostics for charging system and will allow you to see if it the generator or regulator that is failing...(Make sure you check all the connections first)....You do not need the low voltage test set they call for a regular multimeter can handle most of the work. The adapter set for water proof ignition systems however makes the process a lot easier.
Para 92 TM 9-8030 has detailed diagnostics for charging system and will allow you to see if it the generator or regulator that is failing...(Make sure you check all the connections first)....You do not need the low voltage test set they call for a regular multimeter can handle most of the work. The adapter set for water proof ignition systems however makes the process a lot easier.
Paul f
- hairpin151
- PFC
- Posts: 74
- Joined: Thu Mar 06, 2008 4:05 am
- Location: Sunny Southwest-AZ
You should get slightly over 24 volts off and about 28.5 running (you can use you multimeter right at the batteries).
Do you have a mechanical or solid state regulator? You can open a mechanical one and check the contacts to see if they are burned/stuck. If it is solid state the are not repairable
Voltage regulators are more prone to total failure than generators which usually they die slowly and/or get very noisy.
Do you have a mechanical or solid state regulator? You can open a mechanical one and check the contacts to see if they are burned/stuck. If it is solid state the are not repairable
Voltage regulators are more prone to total failure than generators which usually they die slowly and/or get very noisy.
Paul f
- hairpin151
- PFC
- Posts: 74
- Joined: Thu Mar 06, 2008 4:05 am
- Location: Sunny Southwest-AZ
- hairpin151
- PFC
- Posts: 74
- Joined: Thu Mar 06, 2008 4:05 am
- Location: Sunny Southwest-AZ