Back to the truck work...

[Cal_Gary]

Hi All,
Took advantage of an eBay deal to pick up a new slide hammer set. I need to replace the pitman arm pivot pin and bushing on my truck. It has nominal wear and play but I'd like to eliminate that to feel a bit less drift when driving.

I also finally got a new camera so I'll post some pictures of the job
More to follow,
Gary

P.S. Hope everyone is doing well since the forum activity seems a bit slow....

[just me]

110F around here so things slow down. Also the Navy DJ3 project has taken priority, so not much with the M37 other than the occasional outing.

[ez8]

Truck had some vaporlock issues during the extreme heat last week so I ordered a fire sleeve for the fuel line running from the pump to the carb bowl. Hopefully that will help as I don't want to install an electric pump if I don't have to.

Other than that it's back to work on the MB to try and get the body sorted out. Always a project around these parts.

Also, low forum activity just means that everyone's trucks are running smoothly and there are no problems, right? RIGHT?

[Cal_Gary]

Thanks for the responses, guys-too hot here in Utah today to do the job.
Will try again this week if the temps cool down.
Gary

[Cal_Gary]

Well I can't find the parts, will update once I figure out where I put them....
Gary

[ez8]

Happens to me all the time.

I put something down somewhere specifically so I'll remember where it is, but then forget where I put it.
I should really sort out the workshop a little bit, but I'll need some more table space to do that.
But, if I have more table space I'll find more stuff to put on the tables.

It's a very dangerous game to play.

[Cal_Gary]

For sure! I just need to commit to neatness and consolidate all of my "waiting to be installed" parts so I know where everything is.... Glad it isn't just me
Gary