E3 Spark Plugs...

Discuss fixes, upgrades and modifications to your M37

Moderators: Cal_Gary, T. Highway, Monkey Man, robi

Post Reply
Cal_Gary
Moderator
Moderator
Posts: 4354
Joined: Mon Oct 22, 2007 5:51 am
Location: Draper, Utah

E3 Spark Plugs...

Post by Cal_Gary »

Hello All,
I'd mentioned at the end of my head gasket project about trying out these E3 plugs so I got a set of the E3.52 plugs, installed them on Wednesday then took a test drive. I noticed just a slight nudge in power; however, a definite upgrade at idle with an improved, smoother idle, and the plugs are warranted for 5 years and are good for 100K miles. The manufacturer also claims a slight fuel savings that I will monitor then report back on.

Oh, I drove the truck to work for this shift and will be chugging up the big hill in about 3 hours from now.

More to follow,
Gary
Cal_Gary
1954 M37 W/W
MVPA Correspondent #28500
G741.org Forum member since 2004
52 M-42
SFC
SFC
Posts: 741
Joined: Fri Feb 03, 2012 12:56 pm

Re: E3 Spark Plugs...

Post by 52 M-42 »

Are these the military waterproof plugs? Could you maybe post a picture of one of the plugs?

Thanks, Gary!
User avatar
w30bob
1SG
1SG
Posts: 2213
Joined: Mon Apr 02, 2012 8:23 am

Re: E3 Spark Plugs...

Post by w30bob »

52,

No, they're regular automotive plugs. They look like a regular spark plug but the ground electrode looks like a three legged coffee table with a square hole in the middle, directly above the center electrode.

Gary,

All kidding aside, whether the plugs improve performance or not, the larger ground electrode surface area of the plug's design will attract more carbon buildup over time than a standard spark plug. Having more electrode means you have more electrode exposed to the products of combustion. These plugs are designed for modern fuel injected engines with hotter spark and more tightly controlled fuel management than the ol' M37 has. Not saying they won't work or make your engine run better........just saying take a peak at them from time to time just to make sure you don't have a fouling issue sneaking up on you. Also, I don't know how you gap these plugs....it doesn't look obvious.....but watch out for large gaps, as they'll make your coil work harder (and shorten its life).

regards,
bob
Cal_Gary
Moderator
Moderator
Posts: 4354
Joined: Mon Oct 22, 2007 5:51 am
Location: Draper, Utah

Re: E3 Spark Plugs...

Post by Cal_Gary »

Thanks guys for your questions and insights. My plugs are civiIian as is my distributor and plug wires. I took the hill this morning running the E3s, didn't do as well as it did the other day although I was able to remain in 3rd gear instead of dropping into 2nd. The weather was cooler last week that might have had an impact. This evening, for a sanity check if nothing else I pulled the E3s and reinstalled my ACs then took another test run downhill then back up. The only difference with the ACs was that the hint of surging showed itself under load-something it did not do with the E3s. So I'm going back to the E3s to run a long-term test on how they perform.

Bob, I hear you on the carbon factor and will check them periodically. Since i can change the set of 6 in 15 minutes it's not a big deal. Also, the gap on the E3s is preset and not adjustable.

52M, here's a photo.
Gary
Attachments
E3 plug vs AC R45.JPG
E3 plug vs AC R45.JPG (13.45 KiB) Viewed 794 times
Cal_Gary
1954 M37 W/W
MVPA Correspondent #28500
G741.org Forum member since 2004
52 M-42
SFC
SFC
Posts: 741
Joined: Fri Feb 03, 2012 12:56 pm

Re: E3 Spark Plugs...

Post by 52 M-42 »

Thanks, guys!

I quit paying much attention to automotive improvements when the stopped using carburetors and started adding circuit boards. :D
Post Reply