53 m37 turn signals

[macibell111]

where can I find a early m37 turn signal switch,I have found early 60s one but don't know if there was one made with douglas connectors,just bought a jeff smith wiring harness and it has accomodations for turn signals so I want to put the right one on, any help out there .thanks everyone for all the previous info on my 37,its great o have people out there willing to help ,I am learning a lot.

[m37jarhead]

I'm by no means an expert on M37 turn signals but I think "early" M37's did not have turn signals.....
maybe only the late "B" models. So your choices on turn signal indicators should be wide open,
There is an extensive discussion on turn signals on this site if you'll do a "search". You will get
some good advice. I chose the later model turn signal setup for my early M37 because of it's higher reliability.
I did have to change out the connectors but that's not a very big deal.
Jerry

[refit1701]

There was a kit for early trucks which involved a square green box with screw terminals, not douglas connectors. I saw a complete kit on ebay last week so they are out there.

[refit1701]

http://www.ebay.com/itm/Jeep-M38-M38A1- ... dd&vxp=mtr

try this.

[Sal]

You can also look into a Signal Stat 900. There available at most auto stores. I know Napa and Amazon sell them. I have one on my truck, it wasn't hard to wire up to the harness that was made up with wiring for directional's. It dosen't come with any type of connectors on the wires so I used a terminal block mounted under the dash.






Sal

[pwrwagonfire]

You can also look into a Signal Stat 900. There available at most auto stores. I know Napa and Amazon sell them. I have one on my truck, it wasn't hard to wire up to the harness that was made up with wiring for directional's. It dosen't come with any type of connectors on the wires so I used a terminal block mounted under the dash.






Sal

I am in the process of wiring one of these into my truck as well...I used spade connectors and heatshrunk over them.

The signal stat was in my truck when I purchased it, however the wiring was ripped out of the dash