LU-4 winch spreader plate measurement needed

[Tuko]

Guys If anyones truck is handy im looking for the center to center measurement for the bolt holes for the spreader plate on top of the winch. I made one today taking measurements off the old one (14 1/4" center to center) and after all that it seems to be no good! 14 1/2" seems like it would be better. let me know what ya get.

Thanks!!
Tuko

[Tuko]

Just some pics for the heck of it. Note my winch does not have the "braden winch co" arch on it.










plate I made wrong apparently possibly correct measurement written on it:

[Tuko]

answered my own question http://www.g741.org/PHPBB/viewtopic.php ... ilit=winch

[Monkey Man]

Searchung (the forums) is the adventure, learning is the reward

MM

[Tuko]

you arent kidding! I googled the measurement and only found the distance between the 2 halves then just searched "winch" on here to see if I missed anything during the rebuild and that popped up, I should have known it was on here. at least I was able to test my photobucket skills