Need measurement on ball joint ?

Tom @ Snake River · Post by **Tom @ Snake River** » Mon Dec 19, 2011 4:20 pm

Anyone have their steering torn apart at the moment ?? I need the measurement on the ball joints on the pitman arm or front crank. Just need to make sure that they are 1".
Thanks, Tom

m15256 · Post by **m15256** » Tue Dec 20, 2011 8:18 pm

Mine is apart at the moment and all cleaned up. Will measure tomorrow if I get a chance and be in touch. Rick

HingsingM37 · Post by **HingsingM37** » Wed Dec 21, 2011 3:32 pm

Tom, I measured the ones on a NOS steering arm p/n 7374765 and they are @1.220" in diameter, just shy of 1-1/4".

Tom @ Snake River · Post by **Tom @ Snake River** » Wed Dec 21, 2011 4:48 pm

I have my 46 WDX torn apart and the balls are 1".
Good to know, I was looking to have some ball joint studs made so that the origional pitman arm could be used on the reverse rotation boxes.
Once in a while, someone will have trouble with the WC or M37 pitman arm fitting onto the splines.

Need measurement on ball joint ?

Need measurement on ball joint ?

Re: Need measurement on ball joint ?

Re: Need measurement on ball joint ?

Re: Need measurement on ball joint ?