Front wiring harness

[m37jarhead]

I'm at the point where it's time to install the new front wiring harness that I bought from Vintage Wiring. The firewall has been painted inside and out so I'm ready to go. I did take pic's of the outside of the firewall before restoration but
the old wiring, cables and hoses were a mixture of jury-rigging, splices, and just plain stupidity and neglect.

Does anyone have some good pic's of the locations of the metal clips used to hold the wiring in place on the firewall and pic''s that might also show which holes in the firewall are used to route the various wires, cables and hoses? I've got most of it kinda'/sorta' figured out but I only want to do this once. Pic's in the TM's have not been a big help.

Any and all pic's via this post or PM'd to me would be welcome.
Thanks
JB

[Carter]

Look on pages 11 & 12 of my Webshots album, might help in your search, might not.

http://news.webshots.com/album/247061965WWtrqv

[WarrenD]

I'll see if I can take some this evening (subject to memory failure...) if you don't get what you need before then. Mine does not have the original harness so I don't know if what is in there is 100% correct. I also don't have a gen/volt reg set-up, have a deuce alternator and turn signals.

[m37jarhead]

Carter: Thanks for the pic's. They answered some of the questions.

WarrenD: Yeah....when you have time send any of the pic's you have.

Thanks.....Much appreciated.

JB

[WarrenD]

I posted 5 shots : http://www.pbase.com/baywing/misc
Couldn't upload them here, sorry.
Hope that helps.

[m37jarhead]

Warren:
Got the five pic's. Great. Exactly what I needed.
Thanks,.......