Steering box rebuild
Moderators: Cal_Gary, T. Highway, Monkey Man, robi
-
- PVT
- Posts: 41
- Joined: Tue Feb 19, 2008 10:14 am
Steering box rebuild
Is there a trick to getting the new lower cover seal over the end of the worm shaft?
sunsetoutpost
-
- SFC
- Posts: 744
- Joined: Thu Dec 18, 2008 4:49 pm
- Location: Monkton, Vermont
- Contact:
Re: Steering box rebuild
A dab of grease on the seal and the shaft, a twisting motion and it should slip on. Be sure it is on before tightening the bolts, dont try to draw it on with the bolts, or you will probably ruin it. (Dont ask me how I know that!)
Tim
Tim
Happiness is enjoying what you already have!
-
- PVT
- Posts: 41
- Joined: Tue Feb 19, 2008 10:14 am
Re: Steering box rebuild
Better yet, chucked the worm shaft in the lathe and rounded the shaft with a file. The new plate with seal just slipped right on with a 1/4 turn and a little oil. Must have had it off and on half-a-dozen times figuring out the shims with no damage.
sunsetoutpost