data plate

TOM R · Post by **TOM R** » Sat Jan 19, 2008 12:15 pm

is there a data plate for above the hand throttle? there are 2 screw holes

gwalker · Post by **gwalker** » Sat Jan 19, 2008 1:39 pm

There is, it reads something like: pull out throttle before fording, so it may have been part of the fording kit I dont recall.

TOM R · Post by **TOM R** » Sat Jan 19, 2008 3:11 pm

well if anyone has 1 let me know please

knattrass · Post by **knattrass** » Sat Jan 19, 2008 4:42 pm

"PULL OUT THROTTLE
WHEN FORDING"

I have ordered a full M37 kit from VPW based on referral from MW. My old says it in all cap.

TOM R · Post by **TOM R** » Fri Feb 22, 2008 6:43 am

ok , what data plate goes above the cold engine hand primer to the left of the colum?

knattrass · Post by **knattrass** » Fri Feb 22, 2008 8:53 am

I believe the data plate above the primer handle references the operation of the winch - no winch- no plate.

Paul in Kempner, TX · Post by **Paul in Kempner, TX** » Fri Feb 22, 2008 9:24 am

If you mean just above and slightly to the left of the engine primer knob, that is the Publications data plate.

TM 9-8030, Paragraph 7. Data, Caution, and Instruction Plates lists these. Often the important safety warnings are covered up or are gone. It's good to know them.

TOM R · Post by **TOM R** » Fri Feb 22, 2008 9:42 am

got the publication one, it must be the winch plate, looks like it is large, just wasn't sure if there was 1 for the primer pump

data plate

data plate

OR...