Gasket question

RADDOX · Post by **RADDOX** » Sat Apr 17, 2010 5:51 am

Looks like I have used up the gasket between the distributor and the block. Does anyone have the correct thickness for the gasket material to make one ?

Glenn · Post by **Glenn** » Sat Apr 17, 2010 9:02 am

The gasket sits down in the indention in the block, it's not flat like you might be thinking. Midwest Military has them made out of cork. They're round like an o-ring, but picture an o-ring made out of square cork.

cuz · Post by **cuz** » Sat Apr 17, 2010 1:29 pm

The square cross section can also be found in rubber.

Just let your fingers do the walking and pick your poison!
http://www.epm.com/square_cut.htm

Post by **T. Highway** » Mon Apr 19, 2010 4:46 am

Couldn't you just use a quad-ring?