Flange Measurements

Sal · Post by **Sal** » Sat Dec 12, 2009 6:23 am

Merry Christmas to all.
I'm replacing all the seals and Companion Flanges on my transfer case with new ones. Can anyone tell me what the diameter measurement should be for a new uncut flange ? I seen in some old posts that some of the NOS flanges could have been turned on a lathe, and in that case I would have to use a redi-sleeve # 99212 . But if the flanges haven't been cut then I wouldn't need the sleeves. All 4 of my "NOS" flanges measure 2.128 in Diameter and the seal #410308 is 2.125. Would I need to sleeve them ?

Chunk · Post by **Chunk** » Sat Dec 12, 2009 9:56 am

I'll measure one. I just took my own and machined it down,and pressed on my own stainless steel sleave that I also machine myself.