Home PTO seal numbers... Anybody?
Moderators: Cal_Gary, T. Highway, Monkey Man, robi
PTO seal numbers... Anybody?
Anybody know some seal numbers for the PTO? Sliding shifter shaft seals,and output shaft seal. Also about those shifter shaft seals... Do they have the little coil tesion spring inside the seal?
-
HingsingM37
- 1SG
- Posts: 1458
- Joined: Sat Oct 20, 2007 3:43 am
- Location: North Carolina
I have down in notes a CR 7513 for the shifter seal. .750x1.375x.250" dual lip with garter spring.
CR#11209 for the PTO output shaft. 1.125x1.874x.250" , single lip with garter spring.You may want to double check these dims as I sold my PTO. I don't have it to look at
CR#11209 for the PTO output shaft. 1.125x1.874x.250" , single lip with garter spring.You may want to double check these dims as I sold my PTO. I don't have it to look at
David
HingsingM37
1958 M37B1
1968 M101A1 Trailer
MVPA# 33078
"Do Not Take Counsel of Your Fears"
General George S. Patton Jr.
"Those who pound their guns into plows, will plow for those who do not".
HingsingM37
1958 M37B1
1968 M101A1 Trailer
MVPA# 33078
"Do Not Take Counsel of Your Fears"
General George S. Patton Jr.
"Those who pound their guns into plows, will plow for those who do not".
That's the same part numbers shown on the M37 cross ref parts list I downloaded from Cabel's site here last week.
Wes K
wsknettl@centurytel.net
54 M37, 66 M101, 45MB, 51 M38, 60 CJ5, 46 T3-C
MVPA 22099
Disclaimer: Any data posted is for general info only and may not be M37 specific or meet with the approval of some esteemed gurus.
wsknettl@centurytel.net
54 M37, 66 M101, 45MB, 51 M38, 60 CJ5, 46 T3-C
MVPA 22099
Disclaimer: Any data posted is for general info only and may not be M37 specific or meet with the approval of some esteemed gurus.