I need the tracks that bolt to the door that are in the drivers side door that the window frame runs in.

I am getting ready to put in a gm hydra boost M/C set up but I am cannot decide whether to put in hanging pedals or put it where the orig mc is at?? Any advice?? I have done lots of measuring and it will fit just would have to put in a access pannel under the drivers seat to fill the mc.

As long as I know you will get them I can put them beside my garage for a month or so. As far as I know they are stock ratio.

I have the front and rear axles out of my m37, they need to go. The front end is in good shape and the rear end has a broken shaft or somthing. They are both complete and have rims and tires on them. I am pulling them this weekend or early next week. If someone wants them they can have them but they...

I am getting ready to start a engine, tranny, t-case and axle swap. I will have a engine (needs a rebuild), tranny, t-case, driveshafts, and axles 4 sale. Make offer on parts
They are in Bremerton WA (by seattle WA)

Sounds like I am going to have to do it and see what happens. I have stacks of toyota parts laying around so I should be able to get the front the right width.
Now all I have to do is decide what engine to run. Thinking chevy 4.3 with a sm420 tranny

I have done some research so far going to do some more
The fj axle is a 9.5" axle not the 8" that is in the trucks. Has 30 spline axles. The curb weight of the fj60 is like 4900lb.
Also the benifit I see if the rear axle is offset like the m37 axle.

I will admit petronix makes a great product. I have only had one go out and put in about 150, they stood behind it no problem. I have been putting them in boats for 10 years, work great. Fighting points in a moist area is a fun thing, not. As for a performane thing, all they do is tell the coil to f...

Any body put toyota FJ60 axles under a m37. Got a set kicking around and would like to put some newer axles under my truck. They look like they will work.

I am looking for the frame for the drivers door window and regulator. I can put new glass in just really need the frame. Would consider a whole door if it close to washington state as shipping would be high.

What junk yard here around Bremerton/kitsap had any m37s

Thanks
Scott