Amazing!!!

Yes! but it is a good reason to travel too!!
not sure why but despite having more shipping cost than the part I also have issues with customs here...

no. Im refering to the 3 you describe. I have to replace them. Will have to travel to the US

pictures!!!

Nice topic!!
with that new weather strip the window might get heavy when lifted isn't it?
can you share more pics? thank you!!

I've never seen that wrench...
I've always used a flat screwdriver and a normal wrench. But I've never done a valve lash adjustment on these engines. just overhead valve cams hehe

lovely.
Those are the smallest in design?
I remember another post there was this discussion.

ashyers wrote: ↑Tue Apr 26, 2022 4:46 am We played with one on the dyno and advancing it up to 8 did nothing and going further didn't make much sense.

amazing info!!!

PoW wrote: ↑Sat Apr 23, 2022 9:03 pm The yoke is no joke.

PoW

hehhehehe very true!!!

I'm a joke!!!

thank you guys!! on my previous post I wrote "president" meaning preload... On the TM it makes you disassemble the whole diff but I'm not sure if the preload to the pinion itself it's done by adjusting the joke nut or if there is another nut there. If you guys have replaced seal by only re...

hello guys! I have a leak in front diff. pinion shaft seal. As far as I can see the joke is in charge of giving president load to the pinion. So my question is: do I have to remove the complete diff housing to replace that seal? or am I confused and the joke can go out with no need of preload cares?...

thanks guys

hello Seba. Sorry for the delay! unbelievable... world is too small!! heheheh

I'm 39 from Rosario and with the same dream!!!

keep us updated!!

ensure there is correct transmission breath. if ther is internal pressure then it will he expected to have leaks.
I've seen that In JD tractors front wheel drive axels.

thanks for the info!!.
can you add a pictureans the resistor wattage?
Ronnie