leaking rear diffrential

Discuss fixes, upgrades and modifications to your M37

Moderators: Cal_Gary, T. Highway, Monkey Man, robi

Post Reply
poor rich
CPL
CPL
Posts: 145
Joined: Sun Mar 02, 2008 6:20 pm
Location: Port Washington WI

leaking rear diffrential

Post by poor rich »

on sunday I had opertunity to drive my m37 to the hardware store and back, aprox. 7 miles ( I havent gotten the original tires replaced yet, and dont want to stray to far from home). When I got home I was disapointed to find my rear diff. dripping alot of grease.
I inspected expecting to find a bad shaft seal, but was supprised to find the "flang" between the u joint and the seal, the seal and the front inch of the pumkin were the only things not covered in gear lub, the best I can figure is the top of the diff. housing gasket must leak. if this is so how miserable a job is it going to be to replace it?
Rich
My wife loves to cook, bakes fresh cookies for my lunch every week, and now she wants a 15" Mortar.... life is good!
gwalker
CPL
CPL
Posts: 132
Joined: Fri Dec 07, 2007 9:36 am
Location: palm springs ca.

Post by gwalker »

Is the diff vent hose off or plugged up? Make sure it isnt oil leaking from the transfer case an blowing back.
68 M-715 MVPA# 2710
Cal_Gary
Moderator
Moderator
Posts: 4354
Joined: Mon Oct 22, 2007 5:51 am
Location: Draper, Utah

Post by Cal_Gary »

Not a difficult job pulling the center chunk, as you pull both axle shafts, drop the drive shaft at the rear, remove the center chunk nuts (supporting the center chunk, of course) then sliding it forward to clear the studs and housing, then lower it to ground level. It's a heavy mother if you're removing it by hand. Safer and easier to strap a roller jack to it if you have one.
Gary
Cal_Gary
1954 M37 W/W
MVPA Correspondent #28500
G741.org Forum member since 2004
MSeriesRebuild
1SG
1SG
Posts: 2832
Joined: Sat Oct 20, 2007 4:35 am
Location: Norwood, NC
Contact:

Post by MSeriesRebuild »

Sounds like you are shooting in the dark here. I would strongly suggest you degrease everything under the truck very well. Drive it on a short trip & determine for sure where the leak is coming from before you start making preparations to repair something that quite possibly isn't at fault. You'll be glad you cleaned it up in the end anyway, whatever you have to repair will be a much more pleasurable task if it isn't soaked & dripping in gear lube.
Charles Talbert
www.mseriesrebuild.com
Lifer
1SG
1SG
Posts: 2096
Joined: Sat Oct 20, 2007 3:50 am
Location: Elberton, Georgia, USA

Post by Lifer »

Wise words! :)
"PER ARDUA AD ITER"
poor rich
CPL
CPL
Posts: 145
Joined: Sun Mar 02, 2008 6:20 pm
Location: Port Washington WI

thanks

Post by poor rich »

Turns out all but 3 mounting nuts were atleast 2 turns loose. This will be a great truck some day if I dont keep running into stupid stuff like this.
thants to everyone for your support, it helps me to size up problems and figure out if I should tackel a repair or punt and let the mechanic have at it.
My wife loves to cook, bakes fresh cookies for my lunch every week, and now she wants a 15" Mortar.... life is good!
MSeriesRebuild
1SG
1SG
Posts: 2832
Joined: Sat Oct 20, 2007 4:35 am
Location: Norwood, NC
Contact:

Post by MSeriesRebuild »

I'd watch it closely, if it was that loose the gasket is certainly beat to death. You will need to pull it, clean it, & re-gasket to stop it completely.
Charles Talbert
www.mseriesrebuild.com
Post Reply