Home In my other post I had pictures of my engine after I took the head off and I don't see much wear.
The engine is a standard bore as indicated by the metal tag on the block. Standard Diameter is 3.25
My question is if I measure the bore size what are the:
Maximum out-of-round
Maximum Taper
Engine Tolerance Question
Moderators: Cal_Gary, T. Highway, Monkey Man, robi
-
sturmtyger380
- SFC
- Posts: 577
- Joined: Sun Oct 21, 2007 5:13 pm
- Location: Up State SC
Engine Tolerance Question
47 CJ2A
53 M38A1
52 M37
51 M38
67 M416
?? M101A1
53 M38A1
52 M37
51 M38
67 M416
?? M101A1
-
sturmtyger380
- SFC
- Posts: 577
- Joined: Sun Oct 21, 2007 5:13 pm
- Location: Up State SC
Re: Engine Tolerance Question
Found what I was looking for:
47 CJ2A
53 M38A1
52 M37
51 M38
67 M416
?? M101A1
53 M38A1
52 M37
51 M38
67 M416
?? M101A1