24 volt conderser

[richard 775472]

Hi all,

The other I was in search mode on Midwest Jeep Willys parts site and I found out that there was a 24 volt condenser for sale, so I went back to the shop and look for that condenser on my m37, I didn't find one,,Question; do I need one for M37 1953, Canadian version?

[RMS]

should be located @ 12 O'clock under the distributor cap some times you will find two 12v condensers crammed in there.

[richard 775472]

Well, I did look there and other place, but no luck.

[RMS]

if your truck is on points you need a condenser. if you have a petronics kit a condenser is not required

[richard 775472]

because I don't know to much about mechanic, my friend is a mechanic and will be here Monday .
for now all I can say is that the motor start and run good

[richard 775472]

Well well well, went you right (should be located @ 12 O'clock under the distributor cap some times you will find two 12v condensers crammed in there.) I didn't understood underneath the cover it self, so that wy I couldn't find anything the thing it self--INSIDE was were to look, that's all the deference for me to translate in french. But the end result is that , I'm pretty sur to find them inside when I remove the cap tomorrow.

[Sal]

Richard.It should look something like this once you take the Distributor cap off.

TESTING COIL1.jpg (116.97 KiB) Viewed 1553 times

Sal

[richard 775472]

thanks ,,it was in there,,,,,,,,,,,,,,,,,,,,,,,

any suggestion to where I could find the front end bumper dimention (the full lent - not the winch one)
mind is missing his, this is the last thing left to do and then, = provincial inspection.

[w30bob]

Richard,

The non-winch bumper is 5'3" (63") long from end to end and 7.5 inches tall.

regards,
bob