Clutch Alignment Tool Question

Talk about your truck here

Moderators: Cal_Gary, T. Highway, Monkey Man, robi

Post Reply
m-11
SGT
SGT
Posts: 245
Joined: Wed May 07, 2008 6:42 pm
Location: Stevensville, Montana

Clutch Alignment Tool Question

Post by m-11 »

Searched through the threads and all I found was using an input shaft. Is the input shaft 10 splines x 3/4" ?
Top
User avatar
w30bob
1SG
1SG
Posts: 2213
Joined: Mon Apr 02, 2012 8:23 am

Re: Clutch Alignment Tool Question

Post by w30bob »

Hi M-11,

This says it 11 splines by 1", not 3/4".

http://www.ebay.com/itm/Dodge-Power-Wag ... 61&vxp=mtr

regards,
bob
Top
m-11
SGT
SGT
Posts: 245
Joined: Wed May 07, 2008 6:42 pm
Location: Stevensville, Montana

Re: Clutch Alignment Tool Question

Post by m-11 »

Bob,

I seen that one but wasn't sure if that was accurate. I see 10x 1" not 11. :wink:
Top
Post Reply

Return to “General M37”