Gas can fender brackets

[52m38]

Does any one have a photo or drawing of the fender brackets to mount the gas can holder ? Thanks.

[Oddjob]

I'm sure if you were looking to purchase them they could be found at least listed over at VPW...

http://www.vintagepowerwagons.com/pdf/parts/17hood.pdf

4th page half way down on the right side...

If you still want to fabricate them I can take measurements for you... but for 10$ each plus shipping and time making them it might be easier to purchase them if they are in stock over at VPW... Recently I made myself a crank to turn the engine over by hand I made it for 10$ vs. the 35$ plus shipping so it was worth my time...

If you still want measurements and pictures I'll see what I can do this weekend...

[52m38]

That would be great if you could get those messurements for me. As I'm a hands on kind a guy. I could buy them. But I know I could make them. Thanks. Brett
P.S. sorry for the late reply. I was out of town.

[Oddjob]

I'll work on it and make a PDF file for you... with all the spec's...

[52m38]

Thanks. That would be great.

[mikkelborg]

Could you post the PDF or send a copy to me when you are done please? I need to fabricate the same brackets.

Thank you,
Collin

[Oddjob]

Yeah no problem...

May 9th brackets removed... Should have measurements Monday...

[Oddjob]

It's done... Thought I could do an attachment but doesn't look like it so if you need it PM me your email and I'll send it off... All dimensions are as close as I could get them... Little heat and a good steel brake and you should be good...

[52m38]

Oddjob. PM'd you. Thanks again

[Oddjob]

Attached is the file if anyone else wants it... Big thanks to Robi for getting us set up to attach things like PDF's...

Brian
Oddjob