knuckle flange gasket

Gerry · Post by **Gerry** » Tue May 04, 2010 2:22 pm

Is there a gasket that goes between the outer face of the flanges and the spindle(hub assembly)?
Thanks,

MSeriesRebuild · Post by **MSeriesRebuild** » Fri May 07, 2010 6:13 pm

Gerry wrote:Is there a gasket that goes between the outer face of the flanges and the spindle(hub assembly)?
Thanks,

No gasket was used here, however if you do not seal the flange with anaerobic type gasket maker, the oil in the grease will seep constantly, especially in hot weather.

Gerry · Post by **Gerry** » Sat May 08, 2010 8:40 am

Thanks Charles

knuckle flange gasket

knuckle flange gasket

Re: knuckle flange gasket