Troop seat dimensions needed

[russcal]

Hello, y'all!

Hopefully this isn't too wacky a question... I am looking for various dimension for the rear troop seats out of a M37 to see how close they would be to what I need for my XM152.

I need:

1. Overall length of seat from front edge to rear edge.
2. Height of seat from bed deck
3. Height of upright mounting bracket, bottom to top.
4. Distance of upright mntg brkt from ends of seat.

With these dims I should be able to figure out what I can use to fabricate a set of bench seats for my XM152.

Thanx in andvance and God Bless!

Russ
Proud son of Rose and Wes

[SydneyM37]

Dimensions for the seats and side boards are:

upper board, 2 each side 2.75"x77" (use 1"x3"x8' boards and cut to length )
headache rack, 2.75"x?? (use 1"x3"x6' boards and cut to length)
seat, driver side are 3.5"x77" (use 1"x4"x8' boards and cut to length)
seat, passenger side with rumble seat are 3.5"x61.5" (use 1"x4"x6') otherwise use same dimensions as used on the left side.

seat, passenger side jump are 3.5"x?? (use 1"x4"x6' board and cut to lengths)

Courtesy Cabells site