Sri I didnt see your post, I have most of what you want, but ups from montana is costly you should be able to find the parts closer to home...Phil

I used a gm hydroboost,but you have to add a power steering pump. Works grate and is not hard to mount in the stock location...Phil

Yes I do 7000 miles on it. I dove the truck before I scraped it for parts I shifted real nice and ran good. I think it can be shipped fed ex. I would like 250.00 for it

I have converted a lot of 24 volt rigs to 12 volt using the stock military wiring, You are 100% right about twice the amps, but short of the starter and charging system there is not much load on the wiring. The headlights draw 15 amps on 12 volt and the military switch will handle that. The dash and...

If you want a restord rig for show the 24 volt wiring is the way to go, but if this is you daily driver and trail beater I would convert to 12 volt you can still use most of the 24 volt wiring but have 12 volt lights and a 12 volt coil and alt....Have fun

I have for the most part a montana rustfree body with 2.8 mi .It has been sitting in the montana sun for 20 plus years, I bought it from the gsa in 1985, thay used it as a parts rig and stoled a lot of wierd stuf over the years but what was left was very good. In moving the truck around I slipped wi...

Ok I have had both rigs over the year but never at the same time side by side. I know the m35 cab is larger than the m37, can a m35 top be cut down to fit a m37 and is worth the work? I can find a lot of tops for the m35 in the 200.00 price where a M37 top is around 400.00. There is only two parts o...

Ok I will oil up my hammer, thanks Phil

I am to far away to trade, but why count you put up the building there all over the place....Phil

I have removed the 2 interframes from the main frame and removed the wiper motor and the 2 bolts and nuts in the unper couners. I can not get anything to move or wigle, do want to get riugh with it. There is not a lot of rust it just seams to be stuck any tricks ? thanks Phil

Do thay import that much gas? I never saw a gas station a m37 didnt like with the stock engine, but with a high cube v8 maybe you better find a drop tank for the bed .....Phil in Mt

If your shaft is a inch size( 5/8 3/4 7/8 ect )you can buy a crome rod for a hydro cly and have a machineshop make you a new one the crome will not rust and the rod is heat treated so I will not groove like a soft steel shaft....Phil in Mt

I will have a lot of odds and ends that will go on ebay, I have sold most of the parts truck.but there is a lot of misc stuff in the barn yet. just look at
320229037153 and then go to my list. Or you can still email me and I will get back to you here....Phil in Mt

I have always put the slips up next to the transfer to get them out of the drit and water, but then I am a old jeep man and what do I know?? ....Phil in Mt

Its only money, what is stopping you, you only need one ...Phil in Mt