Search found 5 matches

by Rick O
Tue Nov 24, 2020 5:08 pm
Forum: Technical group
Topic: ignition help please!
Replies: 10
Views: 2257

Re: ignition help please!

OK thanks. I think the VR must be shot. I got 24v leaving the starter. I follow that wire up to the VR. I unscrew the connection and I have 24 at on of the pins. I folow the ony wire leaving that connection, which on mine is a big red one, that goes inside the truck. I find where the next junction i...
by Rick O
Mon Nov 23, 2020 12:34 pm
Forum: Technical group
Topic: ignition help please!
Replies: 10
Views: 2257

Re: ignition help please!

Thank PoW. Could you explain this better for me? Yes, the previous owner replaced the lever with a key. I had been getting power to the keyswitch and then to the coil. When I turned the key the voltage meter worked and went into the green. So, I have power going into the VR, I used to get 24v to the...
by Rick O
Thu Nov 12, 2020 7:38 am
Forum: Technical group
Topic: ignition help please!
Replies: 10
Views: 2257

Re: ignition help please!

Check the oil. Is there any gasoline smell to it? Does it seem "thin" or runny. Valves and rubber diaphragm could be leaking. This lets fuel into the crankcase vs pumping it upward to the carb. Pull the inlet to the carb, crank it over. Is it pumping fuel? Sitting that long with old gas t...
by Rick O
Sun Oct 11, 2020 12:22 pm
Forum: Technical group
Topic: ignition help please!
Replies: 10
Views: 2257

Re: ignition help please!

Well. I figured that part out.

Now to figure out why I am not getting fuel and the fuel pump is not pumping.
by Rick O
Sun Oct 11, 2020 5:04 am
Forum: Technical group
Topic: ignition help please!
Replies: 10
Views: 2257

ignition help please!

Hello, I hope someone can give me some help/advice. I was gifted a 1954 M37 after the owner died. It sat for about 10 years until it came into my hands. It looks like he was doing a frame up restoration. There is what looks like a fresh rebuilt engine in it. It is a T245 engine. I gapped the plugs a...