Thank you!

Anyone knows if the SKF UJ304 u joints will fit on the intermediate shaft? I read on a different thread that Napa #304 will fit so I just want to make sure the SKF UJ304 is a replacement number and fits.

Thank you in advance!

Thank You m-11!

Thank you both! anyone knows the timken numbers for the bearings and cups? Maybe I can find them locally.

Hello, Looking for wisdom/guidence. Looking for opinions in preference between using the roller bearings on the upper side of the steering knuckle as opposed to the bronze cone. And also, Are they the same size? top and bottom I have movement, in/out, on the steering knuckles. I tried adjusting it w...

Thank you!

Thank you, Andy. Everything I read says it is adjusted at 3200 RPM's. Is it that it needs to be acelarated at that rate while adjusting? or that it should not be adjusted to acelerated more than that? I am not understanding the procedure on the TM well.

Have you done it?

Rafael

Hello,
Is it possible to eliminate the governor on a ETW1 carburetor? My M37 runs very slow and it does not accelerate smoothly. It is hard to rev up and dies down when going up-hill.

Rafael

Thank you!

Hello. Thank you for the tip. I am back working on the truck. I have a local Timken dealer near my house so I am going to check there. One more question. What kind of differential is on the M37? Dana?

Thank you! I'll keep posting on the progress.

Thank you! I will work on that soon. I am trying to get the vehicle driving in good condition before I start doing body work. Anyone knows the code for the NAVY gray paint?

Thank you all for the help! and sorry of the late response. I was able to purchase, at great expense mind you, the double bearing and I am in the process of installation. When I pulled the seal, I found that the bearing was not broken but it was not adjusted properly, meaning that the pinion was loo...

Hello and Happy Veterans Day! Hope someone can help me with some information. I have a 1952 M37and I am looking for the front axel pinion bearing. Is the one that goes on the rear part of the axle that connect to the drive shaft. From the information I found it is a double bearing set number 44363-D...

Hello, I purchased an NOS wire harness with Douglas connectors and I am trying to install it in my project. I bought it thinking that there was no difference between early and late models other than the connectors themselves. I believe my vehicle is the late model B1 because the person I bought it f...