Good to know, thank Gary. I assumed it to be like the WW2 jeeps. They would mark under the hood something like Preston 44.

Uttas

I'm looking for a picture of any front upper radiator tank shroud markings. Mine had OCT 58 xxx stenciled on it and
I couldnt read the last part. I'm assuming the first time she was winterized. If anyone knows the full marking please let me know.

Uttas

I have for sale a Sid Beck import NOS Greek front and rear harness. I wasn't happy with the colors and decided to go a different route. I continuity checked all the wires pin to pin and no issues. I'm asking 285 shipped from 85648 AZ. I paid 300 when I bought it 2 years ago. IF you have any question...

Found and purchased. Thanks for the help.

Thanks Gary!! John at Midwest has NOS units but i cant justify the cost at this time. Trying to be somewhat budget minded.

BTT

Cal_Gary, thank you so much for the pictures!! It appears I do have both ends. I'll do some investigating today.

UTTAS

I'm still looking for picture help.

Thanks

Hey friends, Looking for some pics of the fwd and aft ends of the PTO drive shaft for the M-37. I reciently aquired a second winch and both have had the fwd end attached the the lu-4. Both came off an M-715 and both are different. I'm looking to see the correct set up for an M-37. I have located a s...

BTT Still looking!

Elwood,

Thank you that's the answer I was looking for!!!

Hey guys, I may have to pull the transfer rear case output housing to redo my rear output bearing pre-load. I have already removed the companion yoke and seal due to a leak. Upon disassembly the rear yoke was not torqued and had a lot of play. There was no damage to components and this possible pre-...

Hi Uttas, I have a parts truck that has one of those brackets on the dash. It has a little rust on it but will clean up good. It might be awhile until I can work outside long enough to take it off though. It's supposed to get down to 9 degrees tonight and barely above freezing for the rest of the w...

Thanks for the ideas I ended up using my air impact to get the screws out. This was after the hand impact didn't budge the screws. The brake drum came off without issue. The issue was indeed the hub, it was stuck on the spindle shaft. I had to use a pry bay to free it up on whatever the inner bearin...

Ran into an issue today removing a LR hub from my 37. This truck has sat for over 30 years when I got it running and had the brakes working last November. I had good pump-able fluid to all 4 wheels. It is possible the brakes didn't work when i had fluid at the bleeder. I never jacked it up to verify...