Temp gas tank
Posted: Sun Apr 20, 2008 6:00 pm
I remeber reading about hooking up a temp. tank. How is this done and can you use gravity to bypass fuel pump?
Thanks,
Thanks,
Page 1 of 1
Posted: Mon Apr 21, 2008 2:28 am
I plan to let my fuel pump suck out of a 5 gallon boat gas can on the floor via a rigged fuel line for my test run. As for using a gravity feed, I think some folks have done that and there was a recent post regarding a mower tank? I need to test my pump rebuild so I am going this route. I have seen guys also run a fuel line right into their fender mount can.
Posted: Mon Apr 21, 2008 3:29 am
I have a small mower tank wired to the radiator support. The pump draws from that. It works great and I don't have to put much gas in to just back the truck in and out of the garage.
An irony
Posted: Mon Apr 21, 2008 8:10 am
You can call it a Gerry Can!!!! 
Just had to do it!!!!! 
Just had to do it!!!!! Posted: Mon Apr 21, 2008 5:50 pm
That's what I do. Convenient and easy to rig up and remove and fill and all that kind of stuff.refit1701 wrote:I have a small mower tank wired to the radiator support. The pump draws from that. It works great and I don't have to put much gas in to just back the truck in and out of the garage.
Posted: Tue Apr 22, 2008 8:32 am
Thanks all for the advice. Nickathome I am sure my wife will come up with a better name but I wont be able to print it here.
Posted: Wed Apr 23, 2008 10:02 am
How did you guys connect the mower tank to the pump? Did you use an adapter at the pump or did you put the adapter at the end of the short rubber fuel line? Do you recall the size of the adapter? I assume the tank side is a barbed fitting to push a fuel line on.
Thanks again,
Thanks again,