g741.org

mounted lights
gamma goat front directionals
infrareds behind grille

I want to remove the screen on my cowl vent and mount a 12 in led light bar under it that flips up when open the cowl vent
what are yous guyses thoughts on this

I also
mounted a 155 tube on the back of the hardtop above the rear window
mounted bolt cutters in cab
mounted an 81 tube on drivers front fender
bolted a 50 cal can to gas can mount on fender
and wired a horse shoe to the grille

Interesting idea. How will you get it to shine down on the road since it is so close to that long flat hood?

I would agree that it would be too close to the hood and not illuminate the road very well.

Bert

worked on wiring all week , well until Thursday....



when the truck tried to blind me when I stripped the end of one of its wires by slamming the wire strippers into my face
my eye hurt for 3 days and was very blood shot

it is perfectly fine now it looks like nothing ever happened to it

Note to self: strippers jammed into face can cause bloodshot eyes.

Note to self. Continue to use automatic wire strippers.

note to self
next time buy new wiring harness

petronix will be here tomorrow

maybe by the end of the weekend it will run again

it runs

and its for sale
see my ad in swap meet

engine is coming out again putting the stock cam back in it

any one wanna buy a hot cam for a 230 with valve springs and hub

What didn't you like about it? (Which cam was it?)

loved it but it decreased my mpg plus id like to revert back to stock

I ordered it from vpw it is ground by ISKY RACING CAMS
http://www.g741.org/PHPBB/viewtopic.php?f=3&t=7582
specs are in this link

and I'm going 12 volt


engine is disassembled

I don't know how I missed most of your build, but I just caught up! Tell me about your Pertronics ignition, will it work with 12 volts?

swapping distributors to civilian

any one need a military dist