Page 1 of 1
Question for the winch experts
Posted: Sun Jun 07, 2020 6:23 am
by NAM VET
My LU4 seems to work fine, but there is an annoying leak from the driver's side, where the spring brake band adjustment screw goes into the caae. It leaks about a half teaspoon a day, and messes up my driveway. So the seal between the input shaft and the brake band "compartment" is failed. My question: is is possible to remove the brake band "compartment' and replace the shaft oil seal, install a new brake band, and reseal it? MM sells a gasket/seal kit and the brake band. Having someone completely rebuild my winch, which I don't think is necessary, would be expensive. I just would like to stop that leak. Thanks,,,, Hal
Re: Question for the winch experts
Posted: Sun Jun 07, 2020 6:46 am
by NAM VET
going to start with a LU4 manual from MM. Hal
Re: Question for the winch experts
Posted: Tue Jun 09, 2020 8:16 am
by just me
Seal can be done without removing bearing housing. Brake band can be soaked in "Oil Eater" and reused. That stuff is amazing.
Re: Question for the winch experts
Posted: Tue Jun 09, 2020 9:44 am
by NAM VET
OK, found the winch rebuild info in the TM I have. I will try to replace seal without removing the housing, since it appears to be on the distal end of the shaft. thanks. will report back. Hal
Re: Question for the winch experts
Posted: Wed Jun 10, 2020 2:24 pm
by just me
The bearing preload is the gasket stack up. Make sure you have an assortment of gaskets in various thicknesses.
Re: Question for the winch experts
Posted: Wed Jun 10, 2020 2:50 pm
by NAM VET
yes, have a set of gaskets as part of the "kit" on the way from John B. HC