Page 1 of 1
What are these holes for?
Posted: Wed Aug 21, 2019 8:24 am
by 06boblee
- DSC01197 (Small).JPG (115.8 KiB) Viewed 1093 times
- DSC01198 (Small).JPG (99.51 KiB) Viewed 1093 times
These. They are on the passenger side of the trans cover- upper part. There are no captive nuts, but it looks factory. Any guesses?
Re: What are these holes for?
Posted: Wed Aug 21, 2019 10:53 am
by 06boblee
I noticed the part that Midwest Military sells have these holes in them. The pics of trucks that I have looked at seem to not have them.
Re: What are these holes for?
Posted: Wed Aug 21, 2019 11:09 am
by Elwood
Those holes are for mounting the heat distributor assembly for the Personnel Heater Set, Ord. No. 7387271 (the hot water personnel heater, not the Southwind gasoline one).
I uploaded a photo of page 4 of the instructions, which shows the panel and the two knock-out holes, but it's "waiting for validation, administrators have been notified."
Re: What are these holes for?
Posted: Wed Aug 21, 2019 11:40 am
by 06boblee
Thank you Elwood.
Re: What are these holes for?
Posted: Wed Aug 21, 2019 9:12 pm
by Cal_Gary
Not sure which holes you are referencing but there is a floorboard pad kit with push pins that affix down there too.
Gary
Re: What are these holes for?
Posted: Thu Aug 22, 2019 2:30 pm
by 06boblee
Cal_Gary wrote:Not sure which holes you are referencing but there is a floorboard pad kit with push pins that affix down there too.
Gary
I should have been more specific, the two big holes along the top edge of the panel.