Page 1 of 1
oil press. sender
Posted: Tue May 27, 2008 6:33 am
by hairpin151
Anyone got an extra 0-60lbs sender with the metal (Douglas) connector? I'm thinking thats the culprit as my gauge pegs to 60lbs and stays there and I've tried a different gauge,same thing. Any help is appreciated.Thanks.
Posted: Tue May 27, 2008 9:38 am
by hairpin151
Got one from Jay at FLMV,installed and all is well.Thanks
Posted: Tue May 27, 2008 3:46 pm
by monkeymissile
could you post their contact info when you get a chance? I may need one too. Thanks.
Posted: Tue May 27, 2008 3:50 pm
by hairpin151
717-252-4489, dont have their web address in front of me.
If you have the chance ...
Posted: Wed May 28, 2008 4:04 pm
by N1VSM
hairpin151 wrote:Got one from Jay at FLMV,installed and all is well.Thanks
I've been trying to track down a problem in my temp gauge. I checked the wire (it is fine - new), swapped out both the gauge and the sensor with ones that tested good.
Could you (or anyone?) tell me what voltages or resistances I should measure when testing cold and hot?
Posted: Sun Jun 01, 2008 1:41 pm
by hairpin151
I wish I could help but fraid not.I would defer to the 8030 manual possibly.
Posted: Mon Jun 02, 2008 5:46 am
by m-11
Are you looking for this website?
www.flmv.net