g741.org

I figured out a trick to day on how to get out them tough brake drum screws

1.spray w/ penetrating oil
2.beat w/ 2 lb hammer
3.heat w/propane torch
4.beat again w/ 2lb hammer
5.thread a 3/8 in bolt in hole used to press drum off
6.tighten snug then turn bolt 4-6 rotations
7.back off bolt
8.use a big flathead screwdriver w/ visegrips attached for leverage

and they should come right out
if not try again starting with step 1

and brush lots of antiseize on the screws so you don't need to struggle next time

yep i will be trying this this summer

Travis,

By the time you're done with your M37 you are going to be an expert at steps 1-4......it's just that kind of vehicle.

regards,
bob

I'm seeing that already bob