g741.org • Clutch Alignment Tool Question

Page 1 of 1

Clutch Alignment Tool Question

Posted: Wed Jul 22, 2015 12:09 pm

by m-11

Searched through the threads and all I found was using an input shaft. Is the input shaft 10 splines x 3/4" ?

Re: Clutch Alignment Tool Question

Posted: Wed Jul 22, 2015 2:02 pm

by w30bob

Hi M-11,

This says it 11 splines by 1", not 3/4".

http://www.ebay.com/itm/Dodge-Power-Wag ... 61&vxp=mtr

regards,
bob

Re: Clutch Alignment Tool Question

Posted: Wed Jul 22, 2015 3:05 pm

by m-11

Bob,

I seen that one but wasn't sure if that was accurate. I see 10x 1" not 11.