g741.org

Hello All,
I've still got my front clip awaiting reinstall save a part or two (PM to M11) and cooler weather. I like to work in comfort, so these continued 90+ temps slow the workflow. I would think it will start cooling down in another 3 weeks or so.

Anybody else stalled out, waiting on better weather?
Gary

I'm waiting for the northeast winter to ramp up before I start tearing into my truck to install the 4bt/nv4500. Too nice out now, also too many other activities to attend on the weekends around here this time of year.

Waiting for a fractured ankle to heal,so I can put front hub back together.
No weather problems, garage is air conditioned and heated.(waited many years for that)

Too hot here also. I'm not playing with the truck when it is over 80 degrees outside and the sun is beating down. I'll drive it or take it out into the woods where it is cool and shady, but I'm not working on it unless it is in the garage.

Today I've been playing with my new RAK-15 MRE Heater Bracket and my cooler (blood cooler) in the bed of the truck in the garage. I set up the table from the Command Truck Kit, put down the right side troop seat and had a place to sit down and make drawings and notes (and a place to set down tools and a cup of coffee). It was nice. As soon as I get the wiring done for the power distribution system in the bed done, I'll be able to have hot meals and cold beverages. That will be nice.

52 M-42

Thanks guys-I don't feel so guilty now
Gary