Page 1 of 1
seat and side wood slats
Posted: Wed Mar 26, 2014 9:47 am
by lewisgrace
Do any of you knowledgeable people know what type of wood I should use to replace the side and seat slats on my M37, many thanks Bill U.K.
Re: seat and side wood slats
Posted: Wed Mar 26, 2014 10:08 am
by k8icu
The original wood on the truck was either Oak or Ash. Though oak was more common than the ash. You can use what ever wood you like, but it should be a hard wood and not a soft wood. Pine is out maple could be in. Are you going to paint them like original or leave them natural like many owners do?
Re: seat and side wood slats
Posted: Wed Mar 26, 2014 10:44 am
by lewisgrace
Thanks for the info, I can buy American oak here in England so that could be the one to go for. I would like to leave the timber in its natural state, I realise its not as original but they do look the cats whiskers when finished like that.
Re: seat and side wood slats
Posted: Wed Mar 26, 2014 12:15 pm
by 52 M-42
White Oak is what the military used. It's hard and resists rot well.
I've always wanted to make a set out of teak, but after seeing what white oak was selling for, I've always chickened out.
It would be nice looking, though.....
52 M-42
Re: seat and side wood slats
Posted: Thu Mar 27, 2014 11:13 am
by k8icu
Some seats made out of tongue oiled walnut would looks spectacular on the truck. If you want to go with a more modern look see if you can find seats off of a 2.5 or 5 ton truck or even a HMMWV as many of them in the last 10 -15 years have been made out of fiberglass.
Re: seat and side wood slats
Posted: Thu Mar 27, 2014 4:56 pm
by ZGjethro
52 M-42 wrote:White Oak is what the military used. It's hard and resists rot well.
I've always wanted to make a set out of teak, but after seeing what white oak was selling for, I've always chickened out.
It would be nice looking, though.....
52 M-42
My truck is non-military in appearance. It was painted that bright yellow fire departments use. I added three rail sideboards (not original style seats) and was thinking about using teak until I priced it. I ended up using red oak, and it looks pretty good.
Re: seat and side wood slats
Posted: Fri Mar 28, 2014 5:46 am
by 52 M-42
Teak would be gorgeous, but I'm afraid the cost would be just too extravagant. Although, with what I've probably put into my truck over the last 35 years, it probably wouldn't amount to much, overall.
I've also often thought about walnut. Three walls in my living room are covered in walnut with a hand rubbed oil finish, so I have an example of what it would look like.
I just continue to pound into my head "Keep It Stock! Keep It Stock! Keep It Stock!..."
Still, it is a nice fantasy to daydream about.
52 M-42