g741.org

This is a clean 1954 m37 that spent its life inside and you can tell. I have not had one this clean in a LONG time. The fenders are blistered under the headlights but the rest is clean,clean,clean. The bed is immaculate and so is the cab and doors. The corners of cab are solid and the underside of the doors at the seams are spotless. No dents,dings or even extra holes from FD use. No canvas and the engine/tranny are in the bed "supposedly " rebuilt and could not get her running again and they started to put a 454 chevy in it yet did not cut anything yet ! The odometer shows 16000 miles and I swear its true.. only thing missing I can tell is the pintle assembly.This is the only pic I have until Saturday afternoon.
Truck is in Northeasten VT...
ed
STILL HAVE
FRAME,AXLES,TRANNY, RADIATOR, BATT BOX, INNER FENDERS, SOFT TOP BOW, BUMPER, GRILL, HOOD, GUAGE SET, MISC STUFF ALSO.

SOLD LIST
cab (sold)
drivers fender (sold)
passenger front fender (sold)
rear shackle brackets and shackles (sold)
doors and complete windshield (sold)
bumperettes both rear (sold )
soft top both side pieces (sold ) center bow still here
spare tire and rim (sold)
complete engine (sold)
front lift shackles and brackets (sold)
tailgate (sold)
bed (sold)
both front drive lights (sold )
rear driveshaft (sold)
passenger seat back (sold)
bed uprights all 6 (sold)
headlight guards (sold)
t-case (sold)
blackout drive light (sold)
gas tank (sold)
pioneer rack (sold)
tires and rims (sold)

I just added a photo album for this truck. It is under Ed Anderson hey wait that's me !

Ed, tell 'em you don't have to cut anything to install a 454.
I repeat, no cutting required for those who might be thinking of doing it.
454 is an easy install.

That's right don't you have a 454 in your dump ???

snow is coming up here in the cold North and had a few nibbles but want to sell before it disappears under 4 feet of powder so I had to put it on Epay..

Truck looks great, I through a few bids on it. I wish I could go higher. I hope it goes to a good home, looks like a great M.

I understand that ... It is a nice truck if it does not sell it may turn into a winter work project sell in the spring thing...

replaced condenser today and played with the distributor for a bit today and it fired up and idled. The accelerator pump is not working and I think carb needs to be rebuilt as it ran then died probably ran for 15-20 seconds good oil pressure via mechanical guage..

Truck not selling willing to take partial trade now...

Putting this out there to see if there is enough interest before I decide to part this truck .. I have had an offer for less than what I paid and I am not dying to sell it so I thought I would post this here to see who needs what. All items will be for sale if I decide to sell it.. Doors are factory mint, cab is spotless, windshield frame inside and out beautiful, soft top hardware beautiful, Bed has a tiny bit of rust see pic in photo section gate is also beautiful. Fenders rust under headlights very small and useable, running boards spotless and clean, motor is 24volt and complete and I also had it fired. has bed stakes for wood on sides only no front piece. Make an offer via PM and it would be first come first served and I will make a list. I accept paypal but for the big stuff you will need to come get it..

ed

Rear lift shackles and brackets Sold -- 12/20/13

how is the drivers side running board. how much for it. thanks dave

spotless and rust free would like to sell as a pair..

pics in ed Anderson folder in picture folder...

That's a dam shame. Make someone a nice easy resto. ive already saved one from the part out this yr.

how much for running board pair. thanks dave