Page 1 of 1
Warn M13 hubs
Posted: Thu Aug 15, 2013 2:02 pm
by 06boblee
Does anyone have a link or a place to obtain copies of the manuals for these hubs? I aquired a set and want to take them apart and clean them up, but I sure would like to have a "roadmap" to get them back together.
Thanks
Re: Warn M13 hubs
Posted: Thu Aug 15, 2013 2:04 pm
by pwrwagonfire
I have a link on my other computer to a PDF of the manual...it has exactly what you are looking for.
I will see if I can find it.
EDIT: Here you go!
Re: Warn M13 hubs
Posted: Thu Aug 15, 2013 2:34 pm
by 06boblee
Thank you very much!
Re: Warn M13 hubs
Posted: Thu Aug 15, 2013 2:50 pm
by pwrwagonfire
06boblee wrote:Thank you very much!
Not a problem!
I got a set of M13's as well, we're two of the lucky ones!
Re: Warn M13 hubs
Posted: Thu Aug 15, 2013 3:02 pm
by 06boblee
Now that my original quest is done, I may as well try for more- is there a rebuild kit still available for these? I guess it would be o-rings and gaskets. Will the standard M37 hub gaskets work?(there is one inside the hub that looks the same in the pics).
Again, Thanks!
Re: Warn M13 hubs
Posted: Fri Aug 16, 2013 4:02 am
by pwrwagonfire
06boblee wrote:Now that my original quest is done, I may as well try for more- is there a rebuild kit still available for these? I guess it would be o-rings and gaskets. Will the standard M37 hub gaskets work?(there is one inside the hub that looks the same in the pics).
Again, Thanks!
I used RTV silicone in place of paper gaskets on a couple different trucks...works great.
However, if you decide you want to go with the paper, it is FEL-PRO FPG 4390
I am not aware of a re-build kit, but if you find on let me know please!
-T
Re: Warn M13 hubs
Posted: Sat Aug 31, 2013 6:11 am
by 06boblee
I talked to Warn a couple of days ago asking about rebuild kits for the M13 hub. They no longer have ANYTHING for this hub, and according to the guy I talked to the o rings and other parts are a different size from any other warn hub (really?). I am mainly trying to replace the o rings on the dial, does anyone know if they are really an oddball size? If I can find them at Graingers or somewhere else I will post it here.
Re: Warn M13 hubs
Posted: Sat Aug 31, 2013 1:33 pm
by Monkey Man
When I replaced the ones in my hubs years ago I got them by taking the hub to a bearing supply place, they found generic ones that were a good, firm but not stretched fit and also supplied me a little thumbnail sized tube of lube for each one, I think the whole lot for both hubs was under $10 Aud...
MM
Re: Warn M13 hubs
Posted: Mon Sep 02, 2013 11:44 am
by JimC
M13's for me as well.
Re: Warn M13 hubs
Posted: Mon Sep 16, 2013 8:38 pm
by Brigand
If anyone has a single M13 they would part with, I am in need of one. At some point someone installed a Superwinch hub in place of the nearside Warn.
Please let me know if you can help. Thanks.
