Page 1 of 1
LU-4 winch spreader plate measurement needed
Posted: Thu Dec 06, 2012 5:24 pm
by Tuko
Guys If anyones truck is handy im looking for the center to center measurement for the bolt holes for the spreader plate on top of the winch. I made one today taking measurements off the old one (14 1/4" center to center) and after all that it seems to be no good! 14 1/2" seems like it would be better. let me know what ya get.
Thanks!!
Tuko
Re: LU-4 winch spreader plate measurement needed
Posted: Thu Dec 06, 2012 5:48 pm
by Tuko
Just some pics for the heck of it. Note my winch does not have the "braden winch co" arch on it.
plate I made wrong apparently possibly correct measurement written on it:
Re: LU-4 winch spreader plate measurement needed
Posted: Thu Dec 06, 2012 7:10 pm
by Tuko
Re: LU-4 winch spreader plate measurement needed
Posted: Fri Dec 07, 2012 2:28 am
by Monkey Man
Searchung (the forums) is the adventure, learning is the reward
MM
Re: LU-4 winch spreader plate measurement needed
Posted: Fri Dec 07, 2012 4:41 am
by Tuko
you arent kidding! I googled the measurement and only found the distance between the 2 halves then just searched "winch" on here to see if I missed anything during the rebuild and that popped up, I should have known it was on here. at least I was able to test my photobucket skills
