Page 1 of 1

Wiring harness install help

Posted: Thu Nov 29, 2012 11:11 am
by Gerry
Does anyone know where in the manuals or have a location where i can see pictures of the wiring harness goes in all the different clips? None of the clips under the dash where being used so i have no idea how the wire is routed.
Thanks,

Re: Wiring harness install help

Posted: Sun Dec 02, 2012 9:42 am
by majorhitt
[imghttp://i1099.photobucket.com/albums/g389/majorhitt/M37/DSCN0266.jpg][/img]Hello Gerry I took this from the glove box opening looking towards the driver's side. The glove box is removed, the main part of the harness comes from the engine compartment through the two inch hole and turns toward the center of the dash. Each clip will have a mount for the wire and a clip for the large double connector, just past the gauges it'll split up and some to the rear harness and other wires to the circuit breakers and whatever else.

Re: Wiring harness install help

Posted: Sun Dec 02, 2012 9:48 am
by majorhitt
Image OOPS OK Here's the photo I was to put in the previous post

Re: Wiring harness install help

Posted: Sun Dec 02, 2012 11:18 am
by Gerry
Majorhitt ,
Thanks thats perfect.

Re: Wiring harness install help

Posted: Sun Dec 02, 2012 2:00 pm
by Tuko
your poor cowl vent! :shock:

Re: Wiring harness install help

Posted: Mon Dec 03, 2012 3:03 pm
by majorhitt
The cowl vent was that way when I got the truck. I did very little to this M37CDN. I used it a lot around the property, and as a guide when I was working on my other M37. Some day when time and money will allow I would like to do some repairs to this truck