Page 1 of 1
LU4 winch ?
Posted: Mon Apr 23, 2012 4:47 pm
by Wayne64
I need to reseal and do a small repair to the winch and need the correct center to center dimension across the top of the winch. That is side to side on the top support plate. Mine is bent up bad and I need to make a new one.
Thanks much
Re: LU4 winch ?
Posted: Mon Apr 23, 2012 7:44 pm
by Tom @ Snake River
I have new reproduction plates at Snake River 4x4.com
Re: LU4 winch ?
Posted: Tue Apr 24, 2012 3:20 pm
by Wayne64
Thank you Tom for your input. But I still need that dimension as I'm building an improved version out of Stainless Steel with rollers.
Re: LU4 winch ?
Posted: Tue Apr 24, 2012 8:07 pm
by Tom @ Snake River
I went out in the shop and pulled a top plate and came up with 14.5" center to center on the top holes where the plate bolts down.
Re: LU4 winch ?
Posted: Wed Apr 25, 2012 3:05 pm
by Wayne64
I thank you Tom, that was the number I was looking for.
It may take a while, but I'll post pics when it's finished.