Page 1 of 1
dodge m37 knuckle bearings
Posted: Mon Jun 13, 2011 3:07 pm
by nutsfor59
hi,does anyone out there have any tricks or advise on how to install the top and bottom bearings ?? i'm sure you dont pound them on !!! what kind of tool do you use ?? thanks
Re: dodge m37 knuckle bearings
Posted: Tue Jun 14, 2011 1:11 am
by M37UK
I used a plastic mallet to hammer mine on.
Cheers
Re: dodge m37 knuckle bearings
Posted: Tue Jun 14, 2011 9:14 am
by cuz
You didn't see any hints in the manual?
Re: dodge m37 knuckle bearings
Posted: Tue Jun 14, 2011 3:22 pm
by rixm37
Check out this link to a step by step rebuild of the knuckles.
http://imageevent.com/moosecreekmaple/steeringknuckle
Re: dodge m37 knuckle bearings
Posted: Thu Jul 07, 2011 2:56 pm
by pwrwagonfire
M37UK wrote:I used a plastic mallet to hammer mine on.
Cheers
+1
Doesn't the manual say there is some "special" drift for this?
Re: dodge m37 knuckle bearings
Posted: Thu Jul 07, 2011 9:36 pm
by M37UK
pwrwagonfire wrote:M37UK wrote:I used a plastic mallet to hammer mine on.
Cheers
+1
Doesn't the manual say there is some "special" drift for this?
The manual says lots of things but I tend to use what I have available at the time, and the mallet and an old socket was perfect !!
