FS '53 M37 Rolling Chasis with Winch
Posted: Tue Oct 05, 2010 6:16 pm
Engine not running. Water pump frozen. 24V ignition. Carb, air filter. Radiator.
Braden LU4 winch-no rope burns, cable, chain and hook, split bumpers, drive shaft, PTO mated to early transmission. No lever for PTO.
T Case and drive shafts.
Axles complete with differentials and axle shafts.
Steering column-no steering wheel.
Pedals. Fuel tank.
No registration papers. For parts only.
Frame has rust just forward of trans mount. I would not recommend building a truck using this chasis.
Lots of good parts - especially the winch. Email to request pictures.
Los Angeles Ca. area. $2000
Thanks,
Todd
toddferwerda@yahoo.com
626.350.4092
Braden LU4 winch-no rope burns, cable, chain and hook, split bumpers, drive shaft, PTO mated to early transmission. No lever for PTO.
T Case and drive shafts.
Axles complete with differentials and axle shafts.
Steering column-no steering wheel.
Pedals. Fuel tank.
No registration papers. For parts only.
Frame has rust just forward of trans mount. I would not recommend building a truck using this chasis.
Lots of good parts - especially the winch. Email to request pictures.
Los Angeles Ca. area. $2000
Thanks,
Todd
toddferwerda@yahoo.com
626.350.4092