g741.org

Does any one have a photo or drawing of the fender brackets to mount the gas can holder ? Thanks.

I'm sure if you were looking to purchase them they could be found at least listed over at VPW...

http://www.vintagepowerwagons.com/pdf/parts/17hood.pdf

4th page half way down on the right side...

If you still want to fabricate them I can take measurements for you... but for 10$ each plus shipping and time making them it might be easier to purchase them if they are in stock over at VPW... Recently I made myself a crank to turn the engine over by hand I made it for 10$ vs. the 35$ plus shipping so it was worth my time...

If you still want measurements and pictures I'll see what I can do this weekend...

That would be great if you could get those messurements for me. As I'm a hands on kind a guy. I could buy them. But I know I could make them. Thanks. Brett
P.S. sorry for the late reply. I was out of town.

I'll work on it and make a PDF file for you... with all the spec's...

Thanks. That would be great.

Could you post the PDF or send a copy to me when you are done please? I need to fabricate the same brackets.

Thank you,
Collin

Yeah no problem...

May 9th brackets removed... Should have measurements Monday...

It's done... Thought I could do an attachment but doesn't look like it so if you need it PM me your email and I'll send it off... All dimensions are as close as I could get them... Little heat and a good steel brake and you should be good...

Oddjob. PM'd you. Thanks again

Attached is the file if anyone else wants it... Big thanks to Robi for getting us set up to attach things like PDF's...

Brian
Oddjob