Page 1 of 1
installing cup in knuckles
Posted: Wed Apr 21, 2010 10:31 am
by Gerry
Do you install the cups flush with the top and bottom edge? The old cups extend beyond into the cap and shims a little.
Thanks,
Posted: Wed Apr 21, 2010 6:33 pm
by jeepdud
The cups go in the cup holder. Sorry could not resist!!!!
Posted: Sat Apr 24, 2010 4:51 am
by MSeriesRebuild
Installing flush is fine, they will move up or down as you add or remove shims to adjust bearing preload.
Posted: Sat Apr 24, 2010 7:50 am
by Gerry
Thanks Charles