Page 1 of 1
Gasket question
Posted: Sat Apr 17, 2010 5:51 am
by RADDOX
Looks like I have used up the gasket between the distributor and the block. Does anyone have the correct thickness for the gasket material to make one ?
Posted: Sat Apr 17, 2010 9:02 am
by Glenn
The gasket sits down in the indention in the block, it's not flat like you might be thinking. Midwest Military has them made out of cork. They're round like an o-ring, but picture an o-ring made out of square cork.
Posted: Sat Apr 17, 2010 1:29 pm
by cuz
The square cross section can also be found in rubber.
Just let your fingers do the walking and pick your poison!
http://www.epm.com/square_cut.htm
Posted: Mon Apr 19, 2010 4:46 am
by T. Highway
Couldn't you just use a quad-ring?