Page 1 of 1
Front knuckle cone
Posted: Wed Apr 14, 2010 9:43 am
by Gerry
Can someone tell me how far to the bearings onto the studs. Is flush good.
Thanks,
Posted: Thu Apr 15, 2010 11:42 am
by Cal_Gary
Hi Gerry,
I did mine some years ago and recall them being flush (top and bottom) and I stayed with the copper tops and bearing bottoms. I would think the sheer weight would "seat" the bottoms anyway
Gary
Posted: Fri Apr 16, 2010 10:46 am
by Gerry
Thats what I was thinking but if someone had the tool the manual talks about they may of known how its seats them
Thanks,
Posted: Fri Apr 16, 2010 4:36 pm
by MSeriesRebuild
Gerry wrote:Thats what I was thinking but if someone had the tool the manual talks about they may of known how its seats them
Thanks,
It's an absolute must that the bearing cones are bottomed against the shoulder of the pin, makes no difference about flush at the top. Otherwise they will move and destroy the preload setting and you will not be happy with the result.
Posted: Fri Apr 16, 2010 6:36 pm
by Gerry
THANKS Charles