g741.org

Treating rust on seams...

Any tips... I was looking at this spray that eastwood has... Thats supposed to convert the rust behind it... Don't know what you guys recommend but I don't want to go to paint leave the truck out side for some time or it get a little wet and rust start in again from an area I should have treated better... Being that my paint is in a fragile state right now we are going to start treating the areas that are bad and following up with a rattle can over top to give it more protection before we go to final paint...

These rust treatments are ok as a temporary fix but when you go for the final, costly paint job, you need to remove as much rust as possible. Either grinding it away and acid etching the metal or replacing bad sections.

If you just want to get rust to pause until later, hit it with a wire brush and and then spray the rust treatment, followed by a topcoat. Follow the manufacturers recomendations.

I was wondering if anyone had heard of or used this method of removing rust by Electrolytic ? I haven't tried it but it sounds interesting....
http://www.stovebolt.com/techtips/rust/ ... usting.htm

Hi Sal,
Go to the Power Wagon page www.dodgepowerwagon.com
At the top of the forum page is a list of options. Choose "Phil's PW Archives" Then in the archives is a "Search Archives" option. There has been a lot of discussion of the electrolytic rust removal. Several guys have done it and with good results. One guy did an entire frame. You will find a ton of info about it.
Tim

I didn't realize Tim that this was so well know. There's a lot of information on that Dodge power wagon site. I guess using a Stainless Steel Electrode in the basement is a no-no... Looks like it works pretty good. To bad I don't have a swimming pool..LOL Thanks Tim

Sal wrote:I was wondering if anyone had heard of or used this method of removing rust by Electrolytic ? I haven't tried it but it sounds interesting....
http://www.stovebolt.com/techtips/rust/ ... usting.htm

How ironic - I'm doing exactly that with my PTO driveshaft (piece by piece). Works very well as long as you are smart about it. Would definitely do the whole truck in a swimming pool if I could, although I'm sure the lye (that's what I use in the bath) would do nasty things to the liner.